464 iSeries and AS/400e System Builder
13.2 SPCN (power) cables
Use the following table as a reference for the power cords supported on IBM iSeries or
AS/400e systems. For more information use the following online resource:
http://publib.boulder.ibm.com/infocenter/eserver/v1r2s/en_US/index.htm
SPCN cables
#6001 #6001 Power Control Cable - 2 m
The #6001 is a 2 m SPCN Power Control Cable.
The #6001 is a Customer Install Feature.
#6006 #6006 Power Control Cable - 3M
The #6006 is a 3 m SPCN Power Control Cable.
The #6006 is a Customer Install Feature.
#6007 #6007 Power Control Cable - 15M
The #6007 is a 15 m SPCN Power Control Cable.
The #6007 is a Customer Install Feature.
#6008 #6008 Power Control Cable - 6M
The #6008 is a 6 m SPCN Power Control Cable.
The #6008 is a Customer Install Feature.
#6029 #6029 Power Control Cable - 30M
The #6029 is a 30 m SPCN Power Control Cable.
The #6029 is a Customer Install Feature.
Special Power and Control Cables
#1422 #1422 PDU Line Cord
The #1422 PDU Line Cord is used from a rack-mounted device to a #5160/#5161/#5162/#5163/#7188 Power Distribution
Unit in that same rack.
Supported on Model 820, 830, and 840, #0578, #0595, #7104, and #7188 expansion units
Minimum operating system level: OS/400 V5R1
The #1422 is a Customer Install Feature.
#0382 #0382 Remote Control Panel Cable
The #0382 ships a cable to enable remote control on an Model 820, 830, or 840. This cable attaches to a PC parallel port.
An available parallel port (LPT) is needed on the PC instead of a COM port. The parallel port must be configured to use
Enhanced Parallel Port 1.9 (EPP) support, which might require a change in the PC’s Basic Input/Output Services (BIOS).
Check with your PC manufacturer for any assistance.
The Remote Control Panel is installed and used from PCs running the Windows NT 4.0 or Windows 2000 Professional PC
operating system. Some PCs might not support this function due to BIOS or hardware incompatibilities.
Supported on Models 820, 830 and 840
The #0382 is a Customer Install Feature (CIF).
The #0382 Remote Control Panel Cable was withdrawn from marketing on 12 February 2002.
#0383 #0383 Remote Control Panel Cable
The #0383 Remote Control Panel Cable provides a remote control panel parallel port cable. An available parallel port (LPT)
is needed on the PC instead of a communications port. This port must be configured to use Enhanced Parallel Port 1.9
(EPP) support, which might require a change in the PC’s BIOS. It is only supported on PCs running Windows NT 4.0 or
Windows 2000 Professional, and OS/400 V5R2 iSeries Access for Windows running on the Operations Console PC.
iSeries Access clients at OS/400 V5R1 can receive this by ordering the refresh of iSeries Access Family #2645. OS/400
V5R1 clients without an iSeries Access license need to purchase one.
Supported on Models 820, 830, and 840
Minimum operating system level: OS/400 V5R1
The #0383 is a Customer Install Feature.
