Chapter 9. External storage, SANs, QIC, and VXA-2 formats for IBM iSeries and AS/400e servers 309
9.1.2 Disk model identifier
The system configuration list (rack configuration) shows the disk type and model in the format
XXXX-YYY, where the XXXX identifies the CCIN number of the disk and YYY identifies the
potential or actual disk protection and compression. Refer to Chapter 10, “Customer Card
Identification Numbers cross reference” on page 381, for a listing of the CCIN numbers. The
YYY identifiers are:
030: Unprotected or mirrored unit attached to a non-RAID capable controller.
050: Unprotected or mirrored unit attached to a RAID capable controller.
060: Unprotected or mirrored unit attached to a RAID capable controller. Data
compression is active.
070: Non-parity member of a parity (RAID) set. Full capacity. Data compression is
inactive.
071: Parity member of a parity (RAID) set with 16 parity members. Fifteen-sixteenths
capacity. Data compression is inactive.
072: Parity member of a parity (RAID) set with eight parity members. Seven-eighths
capacity. Data compression is inactive.
074: Parity member of a parity (RAID) set with four parity members. Three-fourths
capacity. Data compression is inactive.
078: Parity member of a parity (RAID) set with two parity members. Half capacity. Data
compression is inactive.
080: Non-parity member of a parity (RAID) set. Full capacity. Data compression is active.
082: Parity member of a parity (RAID) set with eight parity members. Seven-eighths
capacity. Data compression is active.
084: Parity member of a parity (RAID) set with four parity members. Three-fourths
capacity. Compression is active.
9337-540
9337-545
9337-580
9337-585
9337-590
9337-595
S
S
S
S
S
1967
1967
4194
4194
8589
8589
4/8
4/8
4/8
4/8
4/8
4/8
#1249
#1249
#1289
#1289
#1290
#1290
15.73
15.73
33.55
33.55
68.71
68.71
13.76
13.76
29.35
29.35
60.12
60.12
D, E, F, 3x0, 50S, 53S,
500, 510, 530, 6x0, Sx0,
720, 730, 740, 820, 830,
840
None
Note 1 Models 0xx and 1xx
Models 2xx/4xx
Models 4xx
Models 545/585/595
Models 5xx
Attach to 9406 D, E, F, 3x0, 50S, 53S, 500, 510, 530, 620, 640, 650, S20, S30, S40, 720, 730,
740 models using input/output processor (IOP) #6500
Attach to 9406 B using IOP #2611
Attach to 9406 D, E, F, 3x0, 50S, 53S, 500, 510, 530, 620, 640, 650, S20, S30, S40 and 720,
730, 740 models using #6501 Tape/Disk Device Controller
Available as stand-alone towers by specifying #2400 for black covers or #2410 for white covers.
Attach using #6501 Tape/Disk Device Controller.
Stand-alone towers. Specify #2405 for black covers or #2410 for white covers.
Can be converted to attach to other supported open systems (RS/6000®, Hewlett Packard
(HP), SUN, and NCR) with specify feature #5001. Includes a controller card, operator panel,
and installation support disk drive.
Note 2 N=No Y=Yes S=Switchable
Note 3 The #1400 4xx controller card with a 4 MB write cache can be installed on any 9337-2xx model to boost performance
by up to 20%.
