Chapter 4. IBM iSeries 270 models 109
#2805
#2806
#2806/#2805 PCI Quad Modem IOA
The #2805/#2806 is a WAN modem adapter with four ports (RJ11). Telephone cable is used to connect to the ports. The
#2806 is the CIM version of the IOA, while the #2805 is non-CIM.
The supported protocols are:
V. 92 56 K Async SLIP/PPP
V.34 Fax applications at data rates up to 33.6K
A minimum of one modem cable must be ordered for each #2805/#2806 and are country- or region-specific. All modem
cables on a system must be the same feature number.
The supported modem cables are:
#1010 Modem Cable-Austria
#1011 Modem Cable-Belgium
#1012 Modem Cable-Africa
#1013 Modem Cable-Israel
#1014 Modem Cable-Italy
#1015 Modem Cable-France
#1016 Modem Cable-Germany
#1017 Modem Cable-United Kingdom
#1018 Modem Cable-Iceland/Sweden
#1019 Modem Cable-Australia
#1020 Modem Cable-China (Hong Kong S.A.R.)/New Zealand
#1021 Modem Cable-Finland/Norway
#1022 Modem Cable-Netherlands
#1023 Modem Cable-Switzerland
#1024 Modem Cable-Denmark
#1025 Modem Cable-U.S./Canada/Japan
Remote Power On through ring indicator, SDLC, and synchronous PPP are not supported.
Minimum operating system level: OS/400 V5R1 with PTFs identified in Information APAR II13079.
#2817 #2817 PCI 155 Mbps MMF ATM IOA
The #2817 PCI 155 Mbps MMF ATM IOA is a 155 Mbps ATM PCI card that allows the server to be attached to an ATM
network using the multi-mode fiber (MMF) 62.5 micron interface. This interface is intended for connection to both local area
switches and direct connection to service provider equipment. The #2817 is used typically where 155 Mbps speed is
required over distances of less than 2 km. The #2817 is capable of supporting both multiple emulated LAN environments
and enhanced TCP/IP performance with OS/400 V5R1.
Technical specifications and industry standards supported are available at the ATM Forum Web site at:
http://www.atmforum.com
This card is a 64-bit card that is allowed to plug into any 32-bit or 64-bit slot.
Minimum operating system level: OS/400 V5R1. Not supported after OS/400 V5R2. Upgrade to Ethernet.
The #2817 is a Customer Install Feature.
#2849 #2849 10/100 Mbps Ethernet Adapter
The #2849 allows an iSeries server to attach to standardized 100 Mbps high-speed Ethernet LANs and allows attachment
to existing 10 Mbps Ethernet LANs. The adapter comes standard with an RJ45 connector for attachment to UTP-5 media.
Cabling for 10 Mbps must be CAT-3 or CAT-5. Cabling for 100 Mbps must be CAT-5 that meets or exceeds Industry Standard
EIA/TIA T568A or T568B. Maximum cable length is 100 meters.
Minimum operating system level: OS/400 V5R2
Not supported on an Integrated Netfinity Server/Integrated xSeries Server.
The #2849 is a Customer Install Feature.The
The #2849 was withdrawn from marketing on 01 June 2006. #5700 PCI 1 Gbps Ethernet IOA is the recommended
replacement.
