Filter
Top Products
Programming NetMaster
59
210140
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
20. Special Vend A Auto-Shutdown
Enable “+020”
This option, when turned on, will force the control to
shutdown during the Programmed Special Vend A
time period, preventing customers from starting a new
cycle after a selected time. “OFF” is displayed on the
VFD when Auto-Shutdown is active.
How to Program Special Vend A Auto-
Shutdown Enable
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 84
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+020” appears in the VFD. Refer
to Figure 85.
Figure 85
4. When “+020” appears in the VFD, press the
START (enter) keypad. The current Special
Vend A Auto-Shutdown Enable parameter value
will appear in the VFD. “0” will be displayed
when Auto-Shutdown is disabled and “255” will
be displayed when Auto-Shutdown is enabled.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current value
displayed in the VFD to the desired value. Refer
to Figure 86.
Figure 86
6. Press the START (enter) keypad when the
correct value appears in the VFD. The next option,
“+021”, will appear in the VFD.
NOTE: To program “+021” (Coin #1 Value), refer
to option 21. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the ready mode. Refer to Figure 2.
C762I
C792I
C860I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
1
32