Filter
Top Products
17
210140
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NetMaster Special Features
Programming NetMaster
NetMaster allows the washer owner to program the
control with the use of the keypad. Audit, diagnostic,
cycle and vend information may be programmed and
retrieved by pressing combinations of the Select Cycle
and Select Wash Temp pads.
For details on programming cycle and vend information,
refer to Programming NetMaster.
Collecting Audit Information
The control will store audit information in its memory
that can be retrieved by pressing various combinations
of Select Cycle and Select Wash Temp pads. NetMaster
will record coins entered, total wash cycles, and total
start pulses.
For more information on the audit features, refer to
Collecting Audit Information.
NOTE: Additional audit information is retrievable
with the Micro-Wand IIIE, the Card Reader or the
Network. Refer to the appropriate instruction
manual.
Testing Machine and NetMaster
Functions
Special programmable diagnostic features built into
NetMaster allow the owner to run specific diagnostic
tests. By opening and closing the service door and then
pressing various sequences of Select Cycle and Select
Wash Temp pads, the owner may perform the
following tests:
● Control Software Version Number
● Service Door Opening Test
● Coin Vault Opening Test
● Coin Drop #1 Input Test
● Coin Drop #2 Input Test
● Lid Switch Input Test
● Pressure Switch Opening Test
● Show Fill Time Test
● Show Drain Time Test
● Start Pulse Test
● Configuration Display Tests
For detailed information on running diagnostic tests,
refer to Testing Machine and NetMaster Functions.
Sales Floor Feature
NetMaster washer has a built-in sales floor routine
used to display all LED lights and the four digits with
the colon and decimal point. This function is designed
to show potential customers the high-tech features of
NetMaster and to verify that all segments of the VFD
work.
For detailed information on using the Sales Floor
feature, refer to Sales Floor Feature.
Rapid Advance Feature
This feature allows the user to quickly advance
through active cycles or advance into a cycle from the
ready mode. This feature is useful when tests must be
performed immediately on a washer currently in an
active cycle. In this case, the user can quickly advance
through the cycles to the ready mode. At this point, the
user can perform the required tests and then return the
washer to the point it was interrupted.
For detailed information on using the Rapid Advance
feature, refer to Rapid Advance Feature.
Clearing the NetMaster Vend Feature
This feature allows the user to return NetMaster back
to the ready mode if coins have been entered but the
full vend price has not yet been satisfied. Refer to
Figure 2.
For more information on using the Clear Vend feature,
refer to Clear Vend Feature.
Communications Mode
This feature allows the washer control to communicate
with the Micro-Wand IIIE, the Card Reader or the
Network. This allows the washer control to be
programmed and have its data read without using the
keypad.
For more detailed information on using the
Communications Mode feature, refer to
Communications Mode.
Coin Drop
The control will accept pulses from a single or dual
coin drop to satisfy vend price. Each coin drop will
have the ability to start or run a cycle.