Filter
Top Products
Programming NetMaster
99
210140
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
50. Special Cycle Extra Wash Time
“+050”
This option allows the owner to set the amount of
additional wash time for the Special Cycle.
How to Program Special Cycle Extra
Wash Time
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 180
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+050” appears in the VFD. Refer
to Figure 181.
Figure 181
4. When “+050” appears in the VFD, press the
START (enter) keypad. The current number of
minutes set for the Special Cycle Extra Wash
Time will appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number of minutes displayed in the VFD to the
desired number of minutes. Refer to Figure 182.
NOTE: The Special Cycle Extra Wash Time can be
set from zero (0) to 15 minutes.
Figure 182
6. Press the START (enter) keypad when the
correct number of minutes appears in the VFD.
The next option, “+051”, will appear in the VFD.
NOTE: The Special Cycle option needs to be
turned on (refer to option 49) for the Special Cycle
Extra Wash Time to take effect.
NOTE: To program “+051” (Special Cycle Extra
Extra-Rinse Time), refer to option 51. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the ready mode. Refer to Figure 2.
C762I
C811I
C811I
C860I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
1
32