Filter
Top Products
123
210140
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Rapid Advance Feature
The Rapid Advance feature allows the owner to
quickly advance through active cycles or advance into
a cycle from the ready mode.
How to Enter Rapid Advance from
Ready Mode
1. If control is in Ready Mode, control must be put
into Manual Mode. Refer to Entering the
Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “rAPd” appears in the display.
3. Press the START (enter) keypad. The VFD will
display cycle time and the START (enter) keypad
LED will flash.
4. Press the START (enter) keypad to start cycle.
How to Enter Rapid Advance During
an Active Cycle
1. Be certain service door is open.
2. While pressing and holding the NORMAL
keypad with one hand, press the HOT keypad
with the other hand. There will be no change on
the VFD display.
Control may be in an active cycle or in the ready mode
to use the Rapid Advance feature.
While in the Rapid Advance Mode, pressing the
START (enter) keypad will advance the washer to the
next cycle step. The cycle indicator lights will tell
which cycle step the washer is in.
For Example: If the washer is in the wash fill/agitate
cycle step, pressing the START (enter) keypad will
advance the washer into the WASH PAUSE cycle step.
Continue pressing the START (enter) keypad until the
cycle is completed.
How to Exit Rapid Advance Feature
1. Advance through the cycles until reaching the
ready mode. Refer to Figure 2.
NOTE: The Rapid Advance/Diagnostic Access
option must be turned on for Rapid Advance to
work. Refer to option 47 in Programming
NetMaster.