Filter
Top Products
15
210140
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Washer Operation
Start Up
When power is applied to the washer, the control will
display INSERT COINS/CARD, the decimal point, and
the vend price. The INSERT COINS/CARD light will
remain lit until the vend price has been satisfied. The
default cycle setting is PERM PRESS, the default
wash water fill temperature is WARM, and the default
rinse water temperature is COLD. The LEDs will be lit
on PERM PRESS and WARM at the start of the cycle.
Refer to Figure 2. These default settings are owner
programmable. Refer to Programming NetMaster.
Ready Mode
Figure 2
To start the cycle, the user must press the START
keypad.
The user will be able to select a different cycle or wash
water temperature by pressing a cycle pad when the
machine is in the ready mode or in the first fill cycle. If
not enough vend is entered to satisfy the vend price, the
control will display the remaining vend price needed to
start the cycle. If the first fill was interrupted to change
the temperature (which requires more money), and the
vend price is not satisfied within 1 minute, the washer
control will go back to the first selection and the cycle
will restart. After the first fill, all key presses will be
ignored, allowing the washer to go through the
complete cycle.
When a cycle is complete, the control will display “:00”
until the lid is opened, a key is pressed, or a coin/card is
entered. When one of these three options occur, the display
will revert back to the ready mode. Refer to Figure 2.
Cycle Sequence
Upon the start of a cycle, NetMaster will display the
total cycle time. The appropriate LEDs will light while
the machine passes through different cycle steps. Any
coin entered after the first fill cycle will be added to
the total coin counter, but the user will not be able to
change cycles or water temperature.
Opening the Washer Lid
If the washer lid is opened anytime except the last three
minutes of a cycle, the VFD will display “LId” and the
timer will stop. Once the lid is closed, the cycle will
restart from the point of interruption. If the lid is opened
in the final three minutes of the final spin cycle, the timer
will continue to count down to the end of the cycle.
The cycle operation will stop and the VFD will display
“LId”. When the timer reaches 0 minutes, the control
will return to the “Ready” mode. Refer to Figure 2.
Signals
There are four options when a signal can be used during
the washer operation. These four options are listed below:
1. End of Cycle Signal
By default, this signal is turned off. If turned on, the
signal sounds for three (3) seconds at the end of a
cycle.
2. Signal On Keypad Depression
By default, this signal is turned on and sounds for
a quarter of a second each time a keypad is pressed.
3. Signal On Coin Drop/Card Insertion
By default, this signal is turned on and will sound
for a quarter of a second each time a coin or card
is entered.
4. Signal for Card Removal (Card Models Only)
By default, this signal is turned on and will sound
one second on and one second off when the
REMOVE CARD LED is flashing.
NOTE: Refer to Programming NetMaster to
program signal options.
Changing Cycles
Cycles and wash temperatures can be changed anytime
during the first fill cycle. After the first fill cycle, all
key presses are ignored.
Selecting a higher priced wash temperature will stop the
first fill cycle, and INSERT COINS/CARD will flash one
(1) second on and one (1) second off until the vend price
has been satisfied. After the vend price has been satisfied,
the cycle will restart with the new wash temperature. If
the vend price is not satisfied within 1 minute, the washer
control will go back to the previously set wash
temperature.
C833I