Filter
Top Products
13
210140
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
VFD Display Identification
Light Emitting Diodes (LEDs)
(Refer to
Figure 1
)
LIGHT EMITTING DIODES (LEDs) are used to
indicate the chosen cycle, wash temperature and cycle
status. See below for information on each LED.
CYCLE LED (NORMAL, PERM PRESS or
DELICATES)
CYCLE LED will remain lit the entire cycle.
WASH TEMP LED (HOT, WARM or COLD)
WASH TEMP LED will remain on until the end of the
cycle or will change to a rinse temperature if programmed
to do so.
WASH LED
WASH LED is lit at the beginning of a Wash cycle and
will remain lit until the wash cycle is complete.
RINSE LED
RINSE LED is lit at the beginning of the Rinse or
Extra Rinse cycle and will remain lit until the cycle is
complete.
SPIN LED
SPIN LED is lit for all Spin cycles.
INSERT COINS/CARD LED
INSERT COINS/CARD LED prompts the user for
coins or a card to satisfy the vend price. Four digits
and decimal point show the vend price remaining to be
satisfied. The vend price displayed will decrease with
each coin inserted. If a new wash temp is selected
during the first fill of the wash cycle and it requires
additional vend, the INSERT COINS/CARD light will
flash one (1) second on and one (1) second off, and the
display will show the vend price remaining to be
satisfied.
REMOVE CARD LED (Card Models Only)
REMOVE CARD LED flashes one second on and one
second off after the START pad has been pressed and
the vend has been deducted from the card. It will also
flash when a card is inserted and no vend amount is
required.
Four 7-Segment Digits
The 7-SEGMENT DIGITS are used to display the
time remaining in a cycle, vend price, error messages
and descriptive codes. When displaying the time
remaining the colon will flash, and when displaying
the vend price the decimal point may be lit. During
diagnostic testing or manual programming of the
control, these digits will display descriptive codes and
values (as described in Entering the Manual Mode).