Filter
Top Products
Allen-Bradley 160-Series AC Drives
53
F232120
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Viewing a Display Group
(Parameters #1 – 16 for Series A & B or
Parameters #1 – 19 for Series C)
1. Install PKM on A-B 160 drive. Refer to
“Installation/Removal”.
2. Turn on machine power.
3. Select the desired parameter by pressing the Up
and Down arrow keys . The parameter
value is shown in the last four digits of the
display.
Viewing a Program Group
(Parameters #30 – 80 for Series A & B or
Parameters #30 – 86 for Series C)
1. Install PKM on A-B 160 drive. Refer to
“Installation/Removal.”
2. Turn on machine power.
3. The PKM begins in Display. Press the ESC key
to enter the Program Group.
NOTE: Confirmation of the mode is presented by a
decimal point after the second parameter digit.
4. Parameter #30 should be displayed if entering the
program group for the first time.
5. From this point, parameters #30 – 80 can be
viewed by pressing the Up and Down arrow keys
.
6. To exit the Program Group, press the
ESC key .
Display Mode Parameter Set
01 0.0
30. 5.0
CAUTION
Users are prohibited from changing
parameter values unless specifically
instructed by the washer-extractor
manufacturer. Modification to parameter
values may present potential harmful
operating conditions for both hardware and
personnel.
W673
ESC
ESC
1
Output Frequency
2
Output Voltage
3
Output Current
4
Output Power
5
Bus Voltage
6
Frequency Command
7
Last Fault
8
Heatsink Temperature
9
Controller Status
10
Controller Type
11
Control Version
12
Input Status
13
Power Factor Angle
14
Memory Probe Address
15
Preset Status
16
Balance Angle
*17
Fault Buffer 0
*18
Fault Buffer 1
*19
Fault Buffer 2
Table 33