Installed Software 73
E-EQ-MX3XRG-H MX3X Reference Guide
LXE RFTerm (Option)
Installed by LXE. The application can be accessed by tapping Start | Programs | RFTerm. Please
refer to “Terminal Emulation Setup” earlier in this guide for RFTerm quick start instruction. Refer
to the “RFTerm Reference Guide” on the LXE Manuals CD for complete information and
instruction. WAV files added by the user should be stored in System\LXE\RFTerm\Sounds.
AppLock (Option)
Installed by LXE. Applications are setup by the Administrator by tapping Start | Settings |
Control Panel | Administration. Configuration parameters are specified by the AppLock
Administrator for the mobile device end-user. AppLock is password protected by the
Administrator. End-user mode locks the end-user into the configured application or applications.
The end user can still reboot the mobile device and respond to dialog boxes.
See Chapter 6 “AppLock” for instruction.
Wavelink Avalanche Enabler (Option)
The following features are supported by the Wavelink Avalanche Enabler when used in
conjunction with the Avalanche Manager.
After configuration, Enabler files are installed upon initial bootup and after a hard reset. Network
parameter configuration is supported for:
• IP address: DHCP or static IP
• RF network SSID
• DNS hosts (primary, secondary, tertiary)
• Subnet mask
• Enabler update
Related Manual: “Using Wavelink Avalanche on LXE Windows Computers”.
The MX3X has the Avalanche Enabler installation files loaded, but not installed, on the mobile
device when it is shipped from LXE. The installation files are located in the System folder on CE
devices. The installation application must be run manually the first time Avalanche is used.
After the installation application is manually run, a reboot is necessary for the Enabler to begin
normal performance. Following this reboot, the Enabler will by default be an auto-launch
application. This behavior can be modified by accessing the Avalanche Update Settings panel
through the Enabler Interface. The designation of the mobile device to the Avalanche CE Manager
is LXE_MX3X.
LXE CE devices manufactured before October 2006 must have their drivers and system files
upgraded before they can use the Avalanche Enabler functions. Please contact an LXE
representative for details on upgrading the mobile device baseline.
If the user is NOT using Wavelink Avalanche to manage their mobile device, the Enabler
should not be installed on the mobile device(s).
