Summit Client Configuration 171
E-EQ-MX3XRG-H MX3X Reference Guide
Summit Tray Icon
The Summit tray icon provides access to the SCU and is a visual indicator of link status.
The Summit tray icon is displayed when:
• The Summit radio is installed and active.
• The Windows Zero Config utility is not active.
• The Tray Icon setting is On.
Tap the icon to launch the Summit Configuration Utility.
Use the tray icon to view the link status:
Summit client is not currently associated or authenticated to an Access Point.
The signal strength for the currently associated/authenticated Access Point is -80
dBm or weaker.
The signal strength for the currently associated/authenticated Access Point is stronger
than -80dBm but not stronger than -60 dBm.
The signal strength for the currently associated/authenticated Access Point is stronger
than -60 dBm but not stronger than -40 dBm.
The signal strength for the currently associated/authenticated Access Point is stronger
than -40 dBm.
Wireless Zero Config Utility and the Summit Client
• The WZC utility has an icon in the toolbar that looks like networked computers with a red
X through them, indicating that Wireless Zero Config application is enabled but the
connection is inactive at this time (the MX3X is not connected to a network).
• You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to
connect to your network. LXE recommends using the Summit Client Utility to connect to
your network. The Wireless Zero Configuration Utility cannot control the complete set of
security features of the radio.
Select ThirdPartyConfig in the Active Config drop down list as the active profile. Warmboot the
MX3X. The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless
Information control panel. Using the options in the Wireless Zero Config panels, set up client and
security settings. LXE does not recommend use of the Wireless Zero Configuration Utility for
configuring the client device as it cannot be used to configure all supported security protocols.
To switch back to Summit client control, select any other profile in the SCU Active Config drop
down list, except ThirdPartyConfig. Warmboot the MX3X. Wireless client control is passed to the
SCU.
