Getting Started 15
E-EQ-MX3XRG-H MX3X Reference Guide
Use proper electrical and mechanical fastening means for terminating the cable. Properly
sized "crimp" type electrical terminals are an accepted method of termination.
Wiring color codes for LXE supplied DC input power cabling:
Vehicle Supply Wire Color
+24-72 Max VDC (DC +) Brown or White
Return (DC -) Blue or Black
Vehicle Chassis (GND) Green
Figure 1-16 Vehicle Connection Wiring Color Codes
Note: The input power cord for the DC-DC Power Supply uses white, black and green wires.
Some LXE products have DC input power cords with brown, blue and green wires. The
previous table shows the correct electrical connection for either type of cable.
5. Provide mechanical support for the cable by securing it to the vehicle structure at approximately
one foot intervals, taking care not to over tighten and pinch conductors or penetrate outer cable
jacket.
6. Connect the Power Supply to the MX3P by plugging the computer end into the Power Jack on the
endcap.
7. Turn the Power Supply on. The ON LED on the Power Supply illuminates when it is receiving
power from the vehicle.
8. The mobile device CHGR LED illuminates.
12V VDC MX3P Power Cable Connection
9000A060CBL12V POWER CABLE, BARE WIRE, 12 FT, 12V, DC JACK
If the mobile device is in the cradle, it can be either On or in Suspend Mode during this process.
Connect the two-wire end of the power cable to the 12V power source battery terminals.
Provide mechanical support for the cable by securing it to the vehicle structure at approximately
one foot intervals, taking care not to over tighten and pinch conductors or penetrate outer cable
jacket.
Connect the 12V power source to the MX3P by plugging the computer end into the Power Jack on
the endcap.
The mobile device CHGR LED illuminates.
