Settings | Control Panel Options 105
E-EQ-MX3XRG-H MX3X Reference Guide
Change a Virtual Key (F20 or F21) Value
Modify the Registry using the Registry Editor (see section titled “Utilities”). LXE recommends
caution when editing the Registry and also recommends making a backup copy of the registry
before changes are made.
Go to HKEY_LOCAL_MACHINE \ Software \ LXE \ Scanner.
Set either the ScanCodeLeft or ScanCodeRight to be the scan code of the key to be used as the
virtual key when the Virtual Left key (Left Scan key) or Virtual Right key (Right Scan key) is
pressed. The registry requires a decimal value.
COM Ports
Do not connect a tethered scanner to the USB labelled ports:
COM1, COM2 and COM3 Panel Options are Identical.
Figure 3-15 Scanner Properties / COM Port Settings
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
The COM 1 display contains the same parameters as the COM 2 and COM 3 Tab.
“Power on Pin 9” on the COM2 panel is disabled.
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
See the “MX3-RFID Reference Guide” when using an MX3X with an RFID Module.
