Summit Client Configuration 185
E-EQ-MX3XRG-H MX3X Reference Guide
LEAP w/o WPA Authentication
If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type client
parameter to “Open”.
If the AP is configured for network EAP only, set the Auth Type client parameter to “LEAP”.
Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Administrator password and tap OK.
Tap the Config tab.
Figure 5-11 Summit Profile for LEAP w/o WPA
Enter the SSID of the Access Point assigned to this profile.
Set Auth Type to Open. Set EAP Type to LEAP. Set Encryption to Auto WEP.
To use Stored Credentials, tap the Credentials button.
Note: No entries are necessary for Sign-On Credentials as the user will be prompted for the
User name and Password when connecting to the network.
Figure 5-12 Summit LEAP Credentials
Enter the Username or Domain \Username in the Credentials popup text entry box, if desired.
Enter the Password, if desired. Tap OK. Tap the Commit button to save the new profile
configuration.
Perform a warm reset to connect using the new profile configuration.
Please see “WPA/LEAP Authentication” later in this section to configure the client for WPA
LEAP.
Please see “Sign-on Screen for LEAP, EAP-FAST, PEAP/MS-CHAP, and PEAP/GTC” earlier in
this chapter if the username and password are left blank during setup.
