Symbol Client Configuration 213
E-EQ-MX3XRG-H MX3X Reference Guide
Symbol Client Configuration
Prerequisites
• Network SSID or ESSID number of the Access Point
• WEP or LEAP Authentication Protocol Keys
Note: When making changes to profile parameters, the mobile device should be warmbooted
afterwards unless noted otherwise. Symbol options are available on an MX3X device
only.
Access: Tap the Network Connected Icon in the Status Bar
Profile Parameters Menu
Figure 5-60 Symbol NETWLAN Screen
IP Information Tab After the IP Address has been assigned to the mobile device, tap
the Renew button to renew the IP address if necessary. Tap the
Details button to view the Network Connection details.
IPv6 Information Tab This is the TCP/IPv6 information screen. The contents cannot be
edited by the user.
Configuring IPv6:
By default, IPv6 is enabled and an IPv6 broadcast message is sent
on power up. To disable IPv6, run \Windows\ipv6Disable.reg and
perform a warmboot. To enable IPv6, run
\Windows\ipv6Enable.reg and perform a warmboot.
Note: These utilities affect the behavior of the IPv6 on warmboot.
After a coldboot, IPv6 is enabled.
Wireless Information
Tab
Setup Symbol client connection parameters: Encryption,
authentication, WEP, WPA, EAP, etc.
