Filter
Top Products
- 86 -
FAULT STATUS
The Fault Status screen will display the fault code for the current or
last fault that has occurred in Smartdrive. It will also display how
many cycles ago the fault occurred and at what part of the cycle. The
fault code can be checked in Section 11 to identify the repairs that
may be necessary.
Fault Status
Fault code: 130
5 cycles ago
at progress SPIN
DRAIN PUMP TEST
When in diagnostic mode, the FABRIC CARE button turns the drain pump on or off. This can be
helpful if the bowl is still full of water. The pump is run at 50Hz for this test. When in the 50Hz mode,
the pump will not turn on and off every 10 seconds. When running this test the state of the diverter valve
should be known. This is the best method for checking the recirculation system. Always check that there
is no water pumped to drain when the product is recirculating and vice versa.
WATER VALVE TEST
When in diagnostic mode, pressing the HOW DIRTY down button will turn the Cold Water Valve on.
Pressing the HOW DIRTY up button will turn the Hot Water Valve on. The buttons must be held on to
keep the valves on.
RESTART
When in diagnostic mode, pressing the OPTION button will bring
up the Control Option screen.
Control Options
restart recycle
hot bowl clear
Smartdrive defaults to RESTART ON. This is indicated on the screen by the word RESTART
highlighted. To turn RESTART OFF, push the button alongside the word. This will remove the highlight
from the word RESTART. When Smartdrive is being serviced it is more convenient to turn RESTART
OFF. This will allow any fault in the system to show up immediately.
With RESTART ON:
If a fault occurs in Smartdrive, the diagnostic system will detect it. However, instead of displaying a fault
code immediately, Smartdrive will retry several times.
If the fault was only of temporary nature, Smartdrive will finish the cycle.
If there is a continuous fault Smartdrive will retry a number of times. This process could take up to 8
minutes depending on the type of fault. After this, if Smartdrive still cannot restart, the fault code is
displayed and will beep continuously.
The status of RESTART is indicated during normal use of Smartdrive as follows: -
If none of the 5 green “HOW DIRTY” LED’s are on, RESTART is on.
If the 5 green “HOW DIRTY” LED’s are flashing, RESTART is off.
NB: RESTART is designed as a service aid only and should be left ON in the customer’s home. To
return to normal operation, and to reset RESTART to the default setting, switch Smartdrive off at the
wall. If this does not reset the state then RESTART and RECYCLE must be reset in EEPROM. To set
these states hold down the button adjacent to the LCD for 2 seconds, Smartdrive will beep once.