Filter
Top Products
- 50 -
44. (00101100) Phase 2 to 5 - Water in Bowl During Spin
The Display has sensed a water level in the bowl during spin. This may be caused by a slow
pump out rate due to pump hose or pump partial blockage.
Primary Source - Pump System
Action
1. Check that the pump hose is not squashed or kinked.
2. Check the length of the drain hose and try to reduce the length if excessively long. A 1
metre extension hose of the same diameter fitted to the existing hose is the maximum
allowable length.
3. If the bowl is empty of water, remove the pump from the pump housing and check that it is
not blocked. Also check that the drain hose is not blocked.
4. If the bowl contains water, then service the pump from the top of Smartdrive by removing
the top deck and inner bowl. Bail out the water, remove the pump cap and hood and clear
the pump of any obstruction.
5. Check that the water is not siphoning back into Smartdrive when the pump turns off when
the spin speed reaches 600 rpm.
Secondary Source - Motor Controller
Action - Replace Motor Controller.
45. (00101101) Phase 5 - Display Fault
On power up the display module has tested its ROM is corrupt.
Primary Source - Display module
Action - Replace Display module
46. (00101110) Phase 5 IW - Display EEPROM Check
The Intuitive display has detected a problem with its internal EEPROM.
Primary Source – IW Display module
Action - Replace IW Display module