Filter
Top Products
- 31 -
8.0 DIAGNOSTIC MODE
Allows the following status information to be
determined: -
Last Fault.
Lid switch status.
Out of Balance switch status.
Size.
Additional information
Allows control of the following:-
Pump
Hot Water Valve
Cold Water Valve
Restart
Recycle
Hot Bowl Flag
For IW information see Appendix E.
8.1 WHAT WAS THE LAST FAULT?
To enter Diagnostic Mode turn the power on at the power
point and off at the console. Press and hold the WASH
TEMPERATURE DOWN then press the POWER button.
Smartdrive will give 2 short beeps. Phase 1 & 2 Only press
ADVANCE button once.
From Diagnostic mode press the SPIN buttons until the
HOLD and SLOW SPIN LEDs are on, (Diagnostic mode
level 3). The WASH PROGRESS LEDs will now display the
fault code.
Advance
short
wash
rinse spin
1248163264128
Wash progress LED's Binary Code
Fault Code: 32+16+1 = 49
Note
This window for the LED is not
there on some LW & AW models.
The LED will still be visible under
the panel for diagnostic purposes.
Note
The spin LED is used for
optical download. When
downloading it may be
flickering. It will not
necessarily be part of the
fault code.
Power
start
pause
Advance
short
wash
rinse spin
fast
med
slow
hold
spin
speed
delay
start
1
2
4
8
Spin LED's Showing
Diagnostic Mode level
3.
(Last Fault code)
LED on
LED off
Note: The fault code will only be displayed for 8
cycles after the fault has been rectified. If there has
been no fault within the last 8 cycles all the wash
progress LEDs will be off. In this case it is most
unlikely that the Motor Controller will be faulty.