Filter
Top Products
- 32 -
8.2 TEST LID, OUT OF BALANCE, & SIZE SWITCHES
To enter Diagnostic Mode turn the power on at the power
point and off at the console. Press and hold the WASH
TEMPERATURE DOWN then press the POWER button.
Smartdrive will give 2 short beeps.
Phase 3 Only press ADVANCE button once.
Phase 4 & 5 Only press the SPIN SPEED UP button until the
MEDIUM SPIN LED is on, (Diagnostic mode level 4).
The state of the lid is determined by the 12 minute (Phase 2-5)
or 9 minute (Phase 1-2) wash LED.
FIRST RINSE LED = 5- 5.5kg size
FINAL RINSE LED = 6-6.5kg size
SPIN LED = 7-7.5kg size
Activating the Out of Balance lever
under the top deck will cause the 6
minute LED to turn on. The Out of
Balance lever can be activated by moving
the inner bowl towards the right hand
rear corner of the wrapper. It takes 1
second for the LED to respond after the
Out of Balance has been activated.
In this mode the two rinse LEDs and the
spin LED will display the SIZE SWITCH
setting. Phase 1-3, if the Display Module
is not correctly fitted in the console, the
switch is not activated
and the 3 minute wash LED is illuminated. Ensure display is fitted securely.
8.3 TO TEST PUMP & WATER VALVES
To enter Diagnostic Mode turn the power on at the power
point and off at the console. Press and hold the WASH
TEMPERATURE DOWN then press the POWER button.
Smartdrive will give 2 short beeps. Phase 3 Only press
ADVANCE button once.
The REGULAR CYCLE button turns the pump on or off.
The REGULAR LED is on when the pump is on. Use this
feature to drain Smartdrive.
The WASH TEMPERATURE DOWN button turns the Cold Water Valve on. The Cold Water LED
will also turn on.
The WASH TEMPERATURE UP button turns the Hot Water Valve on. The Hot Water LED will also
turn on.