Filter
Top Products
- 84 -
AUTO WATER - Auto Water Level Adjustment
The water level that Smartdrive fills to on auto water level may be
adjusted. Select AUTO WATER. Use the MORE or LESS buttons to
decrease or increase the fill level. NB: If there is not enough water for the
load, check by pausing Smartdrive and pushing the clothes down to see
how much spare water is at the bottom of the bowl. Clothes often float and
Smartdrive can sensethe water under the clothes.
Auto Water Adjust
less ß
ßß
ß--*--à
àà
à more
cancel OK
TEMP - Wash Water Temperature Adjustment
The wash temperatures can be adjusted. Select TEMP. Use the
DOWN or UP buttons to decrease or increase the wash temperature.
Select OK to save the new temperature settings. Each move up or
down is approximately 1
o
C.
Water Temp Adjust
dnß
ßß
ß-----*-----à
àà
àup
cancel OK
AUTO RINSE - Rinse Default Options
This menu changes the rinse option to which Smartdrive defaults.
(Spray and deep is the standard rinse default). It may be desirable to
change the type of rinse selected for a number of reasons. If there is
problem with impurities in the water supply a better wash may be
attained by changing the rinse option to 2 deep rinses. To conserve
water select a single deep rinse or a shower rinse.
Rinse Defaults
single spray&deep
double shower
Single - Short spin followed by 1 deep rinse.
Double - 2 deep rinses.
Spray & Deep - Spray rinse followed by 1 deep rinse.
Shower - Shower rinse.
Shower rinse alternately showers the clothes with water and spins them to remove the sudsy water. It is
not designed to be used with fabric softener as a shower rinse does not use a deep rinse so it cannot
dispense fabric softener correctly.
OTHER OPTIONS
Creasable Spin Speed
The Creasables fabric care option defaults to a slow spin speed
(300rpm). However, a medium spin speed (700rpm) may be selected.
Select OTHER. Select CREASABLE SPIN. Select MEDIUM.
Other Defaults
Creasable Spin
OOB Beeps
OUT OF BALANCE Recovery
While Smartdrive is spinning, if it senses the wash load is out of balance it stops. It retries spinning up to
three times. If an unbalanced load is detected there are two recovery options.
Automatic Recovery Option. Smartdrive tries to automatically correct the out of balance load. It fills
with water and agitates to redistribute the load before trying to spin up again. ‘OOB’ on the LCD is
highlighted.
Machine Stops Option (default). Smartdrive will stop, give a short burst of beeps every five seconds,
and display a message to let you know to redistribute the load more evenly. Use this option to conserve
water.
End of Cycle BEEPS
The number of beeps at the end of the cycle can be set to zero, five (default) or fifteen. Use the DOWN
and UP buttons to decrease or increase the number of beeps. The LCD will display the number of beeps
selected.