Filter
Top Products
- 69 -
12.5 SHAFT & BEARING REMOVAL
1. Fit the spline tool over the shaft. Remove the 1 1/4"AF shaft retaining nut securing the shaft.
2. Lay the outer bowl on its side before removal of the shaft. This ensures that the shaft does not fall
directly onto the floor.
NB: The shaft can only be removed towards the inside of the outer bowl. Remove the shaft. If the shaft
is difficult to remove, use a puller and a mandrel. Refit the thick stator motor clamp plate onto the
outer bowl and secure with the four stator mounting bolts. The stator clamp plate may be used to
hold the legs of the puller in place.
WARNING: Make sure the stator clamp plate is flat before using. If in doubt, replace.
3. Remove the outer bearing using the bearing removal
tool.
WARNING: Do not remove the bearings with a hammer and
drift as serious damage to the bearing housing or outer bowl
may result. Use the bearing removal tool as illustrated .
4. Remove the seal with the aid of a screwdriver handle
levering from side to side.
5. Remove inner bearing using the bearing removal tool.
Insert the threaded rod and extractor washer up from
the bottom of the outer bowl. Place the collar and
large locating spigot on the threaded rod and extract
the bearing.