Filter
Top Products
- 73 -
Appendix B: Technical Bulletins
These are extracts from previous technical bulletins.
WM011 ALTERNATIVE SPARE PARTS FOR PHASE 1
MOTOR CONTROLLER – June 1999 – Phase 1 only
Fisher &Paykel is no longer able to obtain some electronic components to continue the manufacture of the
current Motor Controllers, part number 425243P. We have therefore introduced a redesigned Motor
Controller Module and Display Module.
The new replacement Motor Controller Module fits into the original housing and the wiring is fitted as per
the diagram below. The Display Module electronics uses the same housing as the Phase 2 to 4 display
boards. This display board screws into the console as before.
These modules must be fitted as a pair and are not interchangeable with any other modules.
The new modules are labelled as follows:
426418P Motor Controller Module
426433P Display Module
The older Phase 1 Display modules, part number 425300P will still be available.
SIZE SETTING
It is important that the size setting is set into the module’s memory whenever a replacement module is
fitted. The procedure for setting the size for the new Motor Controller Module is the same procedure used
for Phase 4-5, as follows:
Press and hold the Wash Temperature Up button then press the Power button. Smartdrive will give
4 short beeps and the pattern of the LED’s will change.
• Press the Wash Temperature Up button for 5kg product, press the Water Level Up button for 6kg
product, or press the Spin Speed Up button for 7kg product.
• Press the Power button to exit.
FAULT FINDING / FAULT CODES
Fault finding with these modules, the fault codes for Phase 4 should be used.
IMPORTANT NOTE
When fitting the Display Module to a MW, tape over the Favourite LED, Permanent Press LED and the
Wash Option LED with black insulation tape. This is so the extra LED’s for the GW model will not show
through and cause confusion.
Full fitting instructions will be included in the kit. Please follow these instructions closely, as there are
alterations to the console and pressure tube to be carried out.