Filter
Top Products
- 19 -
5.0 SMARTDRIVE INFORMATION
This information is provided to the user in the ‘Use and Care Manual’. It is included here for
completeness. The user warning information and some information on Option Adjustment mode is also in
this manual.
5.1 Favourite cycle (GW only) – All Phases
The user may have a particular combination of
wash cycle settings that are frequently used, i.e.
Nappy wash, small load of Gym gear, cold water
wash etc. It is possible to programme this favourite
setting into the memory.
1. Press and hold the FAVOURITE button until
beeps are heard and the FAVOURITE LED
starts to flash.
2. Select the preferred wash cycle and other options using buttons as normal.
3. When the desired options are selected, press the FAVOURITE button again. The FAVOURITE LED
will stop flashing.
4. The FAVOURITE CYCLE programme will be retained in memory even if the mains power is
switched off.
5.2 Customising Wash Cycles (GW only) – Phase 3 to 5 only
All the wash cycles can be mini favourite cycles. The Smart Drive can be programmed to automatically
set the wash options and agitation time, when each wash cycle is selected. For instance, the user may
wish to set the Regular cycle to cold wash or set Heavy Duty to include a soak. Once the wash cycles are
programmed, Smartdrive will remember them, even when switched off at the wall.
TO CUSTOMISE THE WASH CYCLES
Press the wash cycle you wish to customise and hold down for 2 seconds. Smartdrive will give two quick
beeps. The wash cycle light will flash telling you that you are in the programming mode.
Select your wash options.
If you would like to decrease the agitation time, press ADVANCE until the required number of green
lights remain. (Each green light in the wash progress represents 3 minutes of agitation.) To increase the
agitation time keep pressing ADVANCE until all the green lights are displayed again.
NB: On Heavy Duty and Wool you can only decrease the wash time
Press the wash cycle again to store your customised cycle. To change your customised wash cycle repeat
these steps. NB. The customised wash cycles cannot be set to start at the rinse or spin stage or utilise
DELAY START.