Filter
Top Products
- 63 -
PHASE 2 TOPDECK SHOWING WIRING CONNECTIONS
4. Disconnect the pressure tube from the pressure sensor.
5. Disconnect display module plug, the motor/pump harness plug and Rotor Position Sensor plug.
Remove the pump earth lead and mains cable earth lead from the Motor Controller Module.
Remove the plugs from the back of the mains cable clamp, undo the 2 screws holding the clamp
and remove the clamp from the console feed the mains cable earth wire through the cable clamp
opening.
NB: DON’T REMOVE THE EARTH CONNECTION FROM THE WRAPPER
6. Remove the two rubber buffers and screws from the front of the top deck. Release the retaining
clips at rear of cabinet using a flat bladed screwdriver. Lift the top deck clear, feeding wiring
through hole in top deck corner of the cabinet.
NB: The top deck cannot be hinged back without first releasing the rear clips from the cabinet and lifting
at the same time.