Filter
Top Products
- 37 -
10.3 No Water (Both Hot and Cold Water LEDs flashing)
This warning is indicated by the cold and hot water LEDs flashing. Smartdrive will
also be making a rippling set of 5 beeps repeated every 6 seconds and the product will
be paused.
1. Check that the taps are turned on.
2. Check that the inlet hoses are connected.
3. Check that the flow rate is not too low. The product requires a minimum flow rate
of 3 litres per minute. Check that the filters on the inlet hose are not blocked. If
the flow rate is always low then fit large bore inlet hoses.
4. Check that the hot water is connected and that the tap is turned on. If your product
is set for 'controlled cold' hot water may still be required for a cold wash.
5. Siphoning. Check the drain hose is not installed too low and is siphoning.
6. Check the size is set correctly.
10.4 Overloaded Product (High Water LED flashing)
This warning is indicated by the high water LED flashing. Smartdrive will also
be making a rippling set of 5 beeps repeated every 6 seconds and the product
will be paused. The product is overloaded.
1. Check that the product is not overloaded. This is more likely on a smaller
size product. Also it may be that the user has selected the wrong water level
this is more likely to be a LW or MW which only has 3 water levels.
2. Check that the rotating bowl assembly is not jammed to the agitator with
any foreign object that may be caught under the agitator skirt.
3. Check that the clutch teeth are not locked together with dirt, detergent or
lint. Check that the teeth are not broken.
10.5 Out of Balance (First Rinse or Final Spin and Current
Spin Speed LED is flashing)
This warning is indicated by a rinse or spin LED and the current spin speed LED flashing. Smartdrive will
also be making a rippling set of 5 beeps repeated every 6 seconds and the product will be paused.
1. Generally this can be caused by a large load. Smartdrive will normally manage to redistribute the load
and spin. Under exceptional circumstances the user may need to redistribute the wash load manually
once the bowl is stationary.
2. Check that Smartdrive is correctly installed, is level and does not wobble.
3. Check the bias spring is fitted between the wrapper and the outer bowl.
4. Check the OOB lever, switch and bracket.
5. Check the switch operates correctly with a multimeter. Resistance should be less than 2 ohms.
6. Check the suspension is not catching or bouncy.
7. Check both balance rings on the inner bowl contain water.
8. The Motor Controller, (Display for Phase 1) should only be replaced if fault code 43.