Filter
Top Products
52
Console Switches and Indicators Test
The console switches and indicators can be tested by pressing the following touchpads:
SOAK - CYCLE SIGNAL - SOAK - CYCLE SIGNAL
within five (5) seconds while the machine is in Standby Mode. The 7-segment LED will display
“dt”.
1. Press the START pad.
Pressing each touchpad will cause a beep to sound and control one or more LEDs as shown.
If none of the LEDs light up:
Visually check that connectors P11 and P12 are inserted all the way into the machine controller.
If these connectors are properly installed, remove P11 and P12 from the control board while the
power is still on.
Fig. 4-3
•
If a particular group of LEDs does not light up:
• A group or combination of LEDs share a common electronic connection. If this connection is
open, all of the LEDs in the group will be disabled. Replace the console panel/touchpad assem-
bly.
If a single LED does not light up:
• Press the touchpad associated with the LED several times. If the LED does not light up, the LED
has failed. Replace the console panel/touchpad assembly.
If no beep sound is heard:
• If the associated LEDs do light up, it is possible that the beeper circuit has failed. Check touchpad
functioning before replacing the control board.
If no washer function is activated when a particular touchpad is pressed:
• If the associated LEDs do light up, it is possible that the control board has failed. Check touchpad
functioning before replacing the control board.
Extra Heavy
Sta tus
Sta rt
St op
Cancel
Soak
Estimated Time
Rem aining
Wash
Rin se
Ext r a
Rin se
Spin &
Fluf f
Cycle
Complete
Heavy
Options
Normal Normal
Light
Refresh
Hot
Wa rm
Wa rm
Wa rm
Cold
Cold
Cold
Cold
Cold
Cold
Assure d
Wat er
Tem p
Lo ud er
Softer
Off
CYCLE
SIGNAL
SOAK