Filter
Top Products
10
End of Cycle Signal
There are three (3) volume levels for the End of Cycle Signal, HIGH, LOW and OFF. Pressing the END
OF CYCLE SIGNAL keypad toggles between these options by lighting one of the LEDs and beeping the
corresponding end of cycle signal at the volume level selected. The LED remains lit during program
mode and running mode until the cycle is complete.
If OFF is selected, no end of cycle signal will beep, but all key and warning beeps are active.
The end of cycle signal is set at a short high pitched, followed by a longer lower pitched tone, repeated
four times.
THERMISTOR RESISTANCE CHART
THERMISTOR RESISTANCE
TEMP
° F
RESISTANCE VALUE
126k - 135k ohms
97k - 102k ohms
75k - 78k ohms
58k - 61k ohms
46k - 47k ohms
36k - 37k ohms
28k - 30k ohms
23k - 24k ohms
18k - 19k ohms
15k - 16k ohms
12k - 13k ohms
10k - 11k ohms
40
50
60
70
80
90
100
110
120
130
140
150
Loosens soils when added to a cycle. Selection of
SOAK will add approximately 16 minutes to the wash
portion of the cycle.
Adds an additional rinse to any cycle.
Adds three, (3), minutes to the final spin time of any
cycle.
DESCRIPTIONS
OPTIONS
Soak
Extra Rinse
Extend Spin
Additional Options