Filter
Top Products
49
Manual Diagnostic Mode
The manual diagnostic mode will enable activation of specific machine functions without having to run
a cycle. Each function test will time out in three (3) minutes. To enter the manual diagnostic mode:
1. Press: SOAK - CYCLE SIGNAL - SOAK - CYCLE SIGNAL
within five (5) seconds while the machine is in Standby Mode. The 7-segment LED will display
“dt”.
2. Press the WATER TEMP keypad. The 7-segment display show “00”. See Nutate and Recircul
ate Test on next page.
In this mode the Peekaboo function is disabled. Opening the lid will stop the drive motor and all
functions.
Running Nutate or Spin
3. Continue with steps in Nutate and Recirculate Test to step 12. At that point, the motor can be
started in Nutate by pressing the START keypad. Nutate speeds are selectable by pressing the
Cycle keypads as shown in the table below. Pressing the START keypad a second time will pause the
motor. Speeds can be changed without pausing the motor. If the lid is opened during this test, it must
be closed and the START keypad must be pressed again to restart the motor.
The motor can be run in Spin by pressing the RINSE & SPIN keypad. The RINSE & SPIN LED will light
up. Then press START. The motor does not need to be paused to change from nutate to spin. When
performing the spin speed test, the Wash LED will flash while the unit is ramping up to speed.
Fig. 4-2
Whitest Whites
Heavy Duty
Normal
Jeans/Darks
Bulky Items
Quick Wash
Delicate Casual
Wool
150
225
250
275
300
300
300
300
60
250
300
400
500
600
800
800
CYCLE
NUTATE
SPEED
SPIN
SPEED
Extra Heavy
Sta tus
Sta rt
St op
Cancel
Soak
Estimated Time
Rem aining
Wash
Rin se
Ext r a
Rin se
Spin &
Fluf f
Cycle
Complete
Heavy
Options
Normal Normal
Light
Refresh
Hot
Wa rm
Wa rm
Wa rm
Cold
Cold
Cold
Cold
Cold
Cold
Assure d
Wat er
Tem p
Lo ud er
Softer
Off
CYCLE
SIGNAL
SOAK