Filter
Top Products
46
Long Fill
L F
If the water fill time exceeds ten (10) minutes, the water valves are turned off and “LF” is
flashed.
Press STOP/CANCEL to clear the display.
PROBLEM POSSIBLE CAUSE SOLUTION
Load is Wrinkled
Not removing load promptly.
Wrong cycle for fabrics being
washed.
Overloading.
Wash water not warm enough
to relax wrinkles. Using warm
rinses.
Hoses reversed.
Unload the washer as soon as it stops.
Use cold rinses and cycles with slow spin
speeds to reduce wrinkling.
Loads should move freely during wash.
Wash smaller loads.
Use Automatic Temperature Control
(ATC) if safe for fabric, use warm or hot
wash water. Use cold rinse water.
Reverse hoses (see Installation Instruc-
tions, Section One.)
Load is Tangled/
Twisted
Clogged Dispensers/
Bleach Leaking/
Bleach on Wrong
Loads
Overloading. Loads should move freely during wash.
Wash smaller loads.
Use of color-safe bleach in chlo-
rine bleach dispenser
Improper use of chlorine bleach
Add color-safe bleach to the detergent
dispenser. Do not use chlorine bleach
dispenser.
Always measure bleach before adding
to the dispenser. Carefully pour into the
dispenser. Wipe up bleach stains.
Power Failure
P F
“PF” flashes if the washer loses power during a running cycle. The washer does not flash
“PF” when it is first plugged in.
Press START to continue the cycle from the moment that power was lost -OR-
Press STOP/CANCEL to clear the display and completely cancel the cycle.
Flood Condition
F L
“FL” flashes if any overfill condition occurs. This condition occurs when excessive water in
the tub causes the overfill switch to trip. The control must realize that the trip was due to an
overfill condition instead of a suds lock condition in order for “FL” to be displayed.
With an overfill condition, the beeper repeats a warning every 10 seconds with no time out.
The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch
resets or power is discontinued to the unit.
Press STOP/CANCEL to clear the display.
ERROR CODES
Processor Reset
Error
E r
This error code is displayed if the control failed to save cycle information during a power
failure. This does not generate an error code beep.
Press STOP/CANCEL to clear the display.