Filter
Top Products
17
Changing Cycles and Options
You can change Cycles and Options any time before Start is pressed.
• A short tone sounds when a change is selected.
• Two short tones sound if an unavailable combination is selected. The last selection will not be
accepted.
Changing Cycles after pressing Start
1. Press STOP/CANCEL twice.
2. Select the desired wash cycle.
3. Press START.
The washer restarts at the beginning of the new cycle.
NOTE: If you do not press the Start within 5 minutes of pausing the washer, the washer automatically
shuts off.
Changing Options after pressing Start
You can change an Option anytime before the selected Option begins.
1. Press STOP/CANCEL.
2. Select the new Option.
3. Press START to continue the cycle.
CYCLES
Use the cycle pads to choose the right washer cycle for the type of fabrics you are washing.
• For most loads, use the default soil level recommended in the preset cycle settings.
• For heavy soil and sturdy fabrics, use a higher soil level setting.
• For light soil and delicate fabrics, use a lower soil level setting.
Fig. 2-16
Drain
During the Drain Mode, the pump motor turns clockwise (as viewed from underneath the
washer). This causes the water pump to draw the water from the tub through the recirculation port,
forcing the drain check ball to seal the drain sump port and force the water through the drain hose.
Drain Check Ball seals off Drain port, due to
positive pump pressure, forcing water out
the drain hose.
Recirculation Check Ball drops from weight of
water in tub and negative pressure from
pump.
To Drain Hose
Pump Direction