Whirlpool GVW9959K-0 Washer User Manual


 
51
WATER INLET AND DISPENSER VALVE, OPERATING PS TEST
If Operating Pressure Switch trips at any time, all water valves should turn off. Press EXTRA RINSE to start
draining after key press #5 to start draining. Press EXTRA RINSE again to turn off the pump.
PRESS TOUCHPAD DISPLAY CONTROL ACTION
1 SOAK Key Dance key press #1
2 CYCLE SIGNAL Key Dance key press #2
3 SOAK Key Dance key press #3
4CYCLE SIGNAL Key Dance key press #4
Presses #1 - #4 must be completed in 5 seconds or the key
dance is not valid.
5WATER TEMP Key press #5, “00” on the display
6WATER TEMP Cold Water Inlet Valve and Fabric Softener dispenser valve
on. Cold/Cold and Normal (above SOIL LEVEL) LEDs will
turn on.
7 SOIL LEVEL Normal LED will turn off and Heavy LED will turn on. Fabric
softener valve will shut off and Fresh water valve will turn on.
8 SOIL LEVEL Heavy LED will turn off and Refresh will turn on. Fresh water
valve will turn off and Detergent dispenser valve will turn on.
9 SOIL LEVEL Refresh LED will turn off and Light LED will turn on.
Detergent valve will turn off and Bleach valve will turn on.
10 SOIL LEVEL This key press turns off the Bleach and turns on the Fabric
Softener.
11 WATER TEMP Cold/Cold LED turns off and Hot/Cold LED turns on. Cold
inlet valve turns off and Hot inlet valve turns on.
12 WATER TEMP Both hot and cold inlet valves turn on.
13 WATER TEMP All valves turn off.
14 STOP/CANCEL All LEDs off Cancel all diagnostics, go back to Off mode.