Filter
Top Products
38
6. There is a tab on the underside of the inner wash plate that corresponds to a slot on the
universal joint. These should fit together when reassembling the inner wash plate over the
universal joint.
NOTE: Do not rotate the inner wash plate when reassembling to the universal joint. Rotating
the plate may move the leveler to it’s tilted position which may cause the grommets to slip.
7. There is a tab on the outer ring of the inner wash plate that fits into a corresponding hole in the
inner ring of the outer wash plate. Install the bolts in the order indicated in Figure 3-20. The
proper torque setting for these bolts is 100 in. - lbs.
8. Install wash dome, aligning the four (4) tabs with the slots in the outer wash plate.
9. There are three (3) tabs on the outer edge of the balance ring that must fit into corresponding
slots in the basket.
Fig. 3-19
Fig. 3-20
Fig. 3-21
1
2
3
4
5
6
U-Joint
Grommets
Tab
Tab
Alignment
Hole
Tab
Tab
Slot
10. Align cut-out in tub ring with recirculating tube and snap ring onto outer tub.
Seal