Filter
Top Products
F8208801
42
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Collecting Audit Information
This feature allows the owner to retrieve audit
information stored in the washer-extractor by pressing a
sequence of pads on the control.
How to Enter Audit Feature
1. Control must be in Manual Mode to start. Refer
to Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“AUdt” appears.
3. Press the START (enter) keypad. “CyC” will
appear.
How to Read Audit Data
1. Use the #3 ( ) or the #6 ( ) keypad to scroll
through various options until the desired option is
shown in the display. Refer to the Audit Options
List, Table 12, for an explaination of the audit
options available.
2. Press the START (enter) keypad once to start the
audit count. At this point, the display will show
the first four-digit segment of the audit value. If
the audit count is 10,000 or higher, press the
START (enter) keypad again to view the last four
digits of the number.
NOTE: The display can show up to 4 digits at one
time. Audit counts 10,000 or higher are separated
into two 4-digit segments. Each time the START
(enter) keypad is pressed in step 2, the display will
show the next 4-digit segment in the audit value. If
the value is 9,999 or less, only one 4-digit segment
will be shown.
3. Press the START (enter) keypad again. The
control will go to the next audit option in the
Audit Options List.
4. To select other audit options, repeat steps 1-4.
How to Exit Audit Feature
Press the #5 (<) keypad.
>
<
Audit Options List
# Display Description
1
“CyC” Total # of machine cycles
2
“rCyC”* Total # of rapid advance cycles
*This option is not available on Software Version 1.
Table 12
>
<