Filter
Top Products
Programming Control
31
F8208801
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
6. IR Access (On/Off) “IrA”
This option allows the owner to enable or disable
allowing the control to be read by an external device.
How to Program the IR Access (On/Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “IrA”
appears in the display.
4. When “IrA” appears in the display, press the
START (enter) keypad. The current IR Access
status will appear in the display.
“on” = Option Enabled
“oFF” = Option Disabled
5. Press the #3 ( ) or the #6 ( ) keypad to change
the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
option, “tFC” will appear in the display.
NOTE: To program “t FC” (Fahrenheit/Celsius),
refer to option 7. To program other options, refer to
the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
7. Fahrenheit/Celsius “t FC”
This option allows the owner to set whether the
display will be shown in Fahrenheit or Celsius.
How to Program Fahrenheit/Celsius
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “tFC”
appears in the display.
4. When “tFC” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number (found below)
corresponds to the current Fahrenheit/Celsius
setting.
CEL = Celsius
FAHr = Fahrenheit
5. Press the #3 ( ) or the #6 ( ) keypad to increase
or decrease the current number to the desired
number.
6. Press the START (enter) keypad when the correct
number of degrees appears in the display. The
new value is saved and the next option, “FH”,
will appear in the display.
NOTE: To program “FH” (Hot Water
Temperature), refer to option 8. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
<
>
<