Filter
Top Products
Programming Control
19
F8208801
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1. Default Cycle “dCYC”
This option allows the owner to set the default cycle
the machine will enter when in the Ready Mode.
How to Program Default Cycle
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. When “dCYC” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current default cycle value.
NOTE: The default cycle can be set from 1 to 30.
4. Press the #3 ( ) or the #6 ( ) keypad to increase
or decrease the current number to the desired
number.
5. Press the START (enter) keypad when the correct
number appears in the display. The next option,
“AUd”, will appear in the display.
NOTE: To program “AUd” (Audio Signal), refer to
option 2 To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<