Filter
Top Products
F8208801
10
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Entering the Manual Mode
For programming, testing, and retrieving information
from the control, it is often necessary to enter the
Manual Mode by following the six simple steps below.
How to Enter the Manual Mode
1. If the washer is in an active cycle, rapid advance
through the cycle. Refer to the Rapid Advance
Feature.
2. Press and hold the #4 keypad and the #1 keypad
at the same time.
3. The display will show “rAPd”.
4. Press the #3 ( ) keypad or the #6 ( ) keypad to
scroll through the options until the desired option
appears in the display.
5. Press the START (enter) keypad.
Manual Mode is broken into three groups: Manual
Programming, Manual Rapid Advance and Manual
Diagnostics. Manual Programming can only be turned
on or off with an external device. Refer to the
appropriate instruction manual. Manual Rapid Advance
and Manual Diagnostics can be turned on and off using
an external device or by manual programming (refer to
13 and 15 of Programming Control).
By default, all groups are turned “ON”.
The manual features available in each group are as
follows (the menu displayed on the display in this
mode is in parentheses).
Manual Programming
Manual Programming (Prog)
Manual Read Audit (AUdt)
Manual Reset (rSEt)
Manual Rapid Advance
Rapid Advance (rAPd)
Manual Diagnostics
Manual Diagnostic Tests (dIAg)
If a group is turned off, the display will change from
the selected feature to “OFF” when the START pad is
pressed and an audio signal will sound for one second.
The display will then return to the selected feature.
The features in the group cannot be entered.
>
<