Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8208801
30
Programming Cycle Time Display
NOTE: This option is not available on Software
Version 1.
NOTE: This programmable option (Cnin) will only
appear if the Programmable Cycle Time Display
option (PCtd) has been enabled.
1. When “Cnin” appears in the display, press the
START (enter) keypad. The current status will be
displayed.
2. Press the #3 ( ) or the #6 ( ) keypad to change
the current value. The cycle time display can be
set from 0 to 255 minutes.
3. Press the START (enter) keypad when the
desired value appears in the display.
NOTE: To program another cycle, repeat Cycle
Programming steps. To program other options
press the the #3 ( ) or the #6 ( ) keypad and refer
to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
5. Number of Balance Retries
“bALr” (Variable Frequency
Drives Only)
This option allows the owner to program how many
times the control will retry balancing the load before
moving into Extract step.
How to Program Number of Balance
Retries
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad, and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “bALr”
appears in the display.
4. When “bALr” appears in the display, press the
START (enter) keypad. The current value will
appear in the display.
5. Press the #3 ( ) or the #6 ( ) keypad to increase
or decrease the current value.
NOTE: The number of balance retries can be set
from 1-7.
6. Press the START (enter) keypad when the
desired value appears in the display. The next
option, “IrA”, will appear in the display.
NOTE: To program “IrA” (IR Access [on/off]),
refer to option 6. To program other options, refer to
the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
<