Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8208801
38
18. Manual Diagnostics (On/Off)
“dAEn”
This option allows the owner to enable or disable the
manual diagnostics option. Refer to Testing Machine
and Electronic Control Functions section for more
information.
How to Program the Manual Diagnostics
(On/Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “dAEn”
appears in the display.
4. When “dAEn” appears in the display, press the
START (enter) keypad. The current Manual
Diagnostics status will appear in the display.
“on” = Option Enabled
“oFF” = Option Disabled
5. Press the #3 ( ) or the #6 ( ) keypad to change
the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
option, “FLo”, will appear in the display.
NOTE: To program “FLo” (Low Water Level),
refer to option 19. To program other options, refer
to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
19. Low Water Level “FLo”
This option allows the owner to program the low water
level during fill and tumble of all cycles.
How to Program Low Water Level
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the #3 ( ) or the #6 ( ) keypad until
“Prog” appears in the display. Press the START
(enter) keypad and “dCYC” will appear in the
display.
3. Press the #3 ( ) or the #6 ( ) keypad to scroll
through the programmable options until “FLo”
appears in the display.
4. When “FLo” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current low water level during tumble and fill of
all cycles.
5. Press the #3 ( ) or the #6 ( ) keypad to increase
or decrease the current water level to the desired
water level.
NOTE: The Low Water Level value can be set from
1 to 10.
6. Press the START (enter) keypad when the correct
number appears in the display. The next option,
“FnEd”, will appear in the display.
NOTE: To program “FnEd” (Medium Water
Level), refer to option 20. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to
Start Mode.
>
<
>
<
>
<
>
<
>
<
>
<