Filter
Top Products
9
F8208801
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Special Features
Programming Control
The control allows the washer-extractor owner to
program the control with the use of the keypad. Cycle
options may be programmed, audit information may
be viewed and diagnostic tests may be run by pressing
combinations of the select cycle keypads.
For details on programming select cycle options, refer to
Programming Control.
Collecting Audit Information
The control will store audit information in its memory
that can be retrieved by pressing various combinations
of Select Cycle keypads. The control will record total
machine cycles.
For more information on the audit features, refer to
Collecting Audit Information.
NOTE: Additional audit information is retrievable
with an external device, using infra-red
communications. Refer to the appropriate
instruction manual.
Testing Machine and Control
Functions
Special diagnostic features built into the control allow
the owner to run specific diagnostic tests. By opening
and closing the access panel and then pressing various
sequences of Select Cycle keypads, the owner may
retrieve or perform the following tests:
• Front End Control Software Version Number
• Output Board Control Software Version Number
• Output Board Water Level Sensor Trim Value
• Access Panel Opening Test
• Door Switch Input Test
• Door Lock Input Test
• Show Fill Time Test
• Show Drain Time Test
• Temperature Sensor Display Test
• Start Pulse Test
• VFD Balance Input Test
• 24 VAC Switch Input Test
• VFD Drive Fault Input Test
• Frame Balance Switch Input Test
• VFD Balance Weight Test
• Water Purge Test
• Water Leak Detection test
For detailed information on running diagnostic tests,
refer to Testing Machine and Control Functions.
Rapid Advance Feature
This feature allows the user to quickly advance
through active cycles. This feature is useful when tests
must be performed immediately on a washer-extractor
currently in an active cycle. In this case, the user can
quickly advance through the cycles to shakeout. At
this point, the user can perform the required tests and
then return the washer-extractor to the point it was
interrupted.
For detailed information on using the Rapid Advance
feature, refer to Rapid Advance Feature.
Communications Mode
This feature allows the control to communicate with
an external device using infra-red communications.
This allows the control to be programmed and have its
data read without using the keypad.
For more detailed information on using the
Communications Mode feature, refer to
Communications Mode.