Filter
Top Products
Operation Manual Section 3: Tool requirements
3-9000-744 Rev F September 2013
Tool list for the extractor tool with T-slot extractable transducers 13
Section 3: Tool requirements
3.1 Tool list for the extractor tool with T-slot
extractable transducers
1
Molykote III is a trademark of Dow Corning Corporation, U.S.A.
Table 3-1 Extractor tool list for T-slot extractable transducers
Tool Tool requirement
3/4” Allen wrench Fits cap screws (Z).
5/16” Allen wrench Fits cap screws that attach the transducer mount (E) to the meter housing.
3/32” Allen wrench Fits the extractor tool valve assembly (H) handle stop peg set screw (HH)
1/16” Allen wrench Fits the transducer holder (K) and transducer stalk assembly (D) set screws (W).
¾” x ¾” open/box wrench
Fits nuts (X) which attach the piston assembly (P) to the lubricator chamber assembly (M).
1-
¼” open end wrench
Fits lubricator chamber extractor rod (N) hexagon nut and transducer holder (K) hexagon
end.
Molykote 111
1
Valve lubricant and sealant to lubricate O-rings before installation.
Nickel Anti-Seize
(P/N 9-9960-134)
Anti-seize thread compound for transducer holder (K).
Screw driver - flat blade To adjust the pressure regulator (V) adjustment screw.
Liquid leak detection fluid Check all joints for sealing integrity. (Not provided by Daniel Measurement and Control.)