Filter
Top Products
Operation Manual Section 2: Operation preparation and part replacement notes
3-9000-744 Rev F September 2013
Operation preparation 11
4. Oral communication must be established prior to depressurizing the line, if required.
5. Enough lighting to see the gauge is required prior to extractor tool usage.
6. Allow at least eight (8) feet of clearance to assemble and install the extractor tool.
CUTTING OR CRUSHING HAZARD
Do not permanently attach any tool (e.g., a ratchet) to the extractor tool. High line
pressure increases the velocity of moving parts which may cut or crush extremities.
Failure to keep extremities clear of the moving parts (e.g., pistons or piston rod) may cause
injury to personnel.
NOISE HAZARD - ORAL COMMUNICATION
Release of pressurized product makes communication with operators and service
technicians difficult.
Operators must develop a method of communication prior to using the extractor tool. Failure to
do so can result in injury.
TRIPPING HAZARD
Clear all obstacles or obstructions from the work area when transporting, handling,
installing or removing the extractor tool.
Failure to keep work areas clear of obstacles and obstructions could result in injury or equipment
damage.