Filter
Top Products
4 Extractor tool specifications
Section 1: Introduction Operation Manual
September 2013 3-9000-744 Rev F
1.2 Extractor tool specifications
The Daniel Extractor Tool is available in two ANSI pressure ratings, 600 and 1500. The pressure
rating is stamped on the Lubricator chamber assembly flange (item M, drawing D-08248). See
Appendix C and Figure 1-4.
Figure 1-4 ANSI Class pressure rating stamp on lubricator chamber assembly flange
A.
A. ANSI Class pressure rating identification location
EXTRACTOR TOOL HANDLING HAZARD
The extractor tool, when it is fully assembled is heavy (144-160 lbs), long (6 ft) and may be difficult to operate in
tight quarters. Take care not to lean on, sit on, or step on the unit.
Failure to follow the handling instructions may cause the tool to fall and cause serious personal injury.