Filter
Top Products
4. Shut down and reboot the DMS client.
You may encounter a situation where the client cannot boot to multi
user mode because the client machine has insufficient memory and the
disk specified to serve as the swap volume does not have the correct file
system type in the disklabel. If this occurs, it will be necessary to reboot
the client to single-user mode and set the disklabel correctly.
1. At the “>>>” prompt type:
>>>boot -flag s {network boot device}
2. After the machine completes the boot process, do the following:
disklabel -sF /dev/rdisk/{swap device} swap
3. Reboot the machine.
13.7 Reconfiguring for a Hardware Update Release
If you are installing a hardware update release and you configure the DMS
environment before you add the operating system hardware update, you
must connect to the root directory in the DMS environment and issue the
following two commands to undo the configuration:
# rm -rf usr/sys/conf/DATALESS
# rm -rf usr/sys/DATALESS
See Appendix D for information about hardware update releases in DMS.
13–4 Troubleshooting DMS