2-8 Using PC Cards
2325 Reference Guide Revision B 2325A137REFGD
Push the card firmly into the slot until the ejector tab slides out.
See section titled “Radio Card Antenna Connector” when installing or
removing an RF card.
Note: Do not force the card into the slot. It should slide in easily. The
PC card slot in the 2325 is designed so that you cannot insert a
card upside down or backward. Make sure you put the end with
the holes into the slot first. Then flip the card upside down and
try to insert it again.
Replace the PC card slot cover and tighten the locking screw.
Card Recognition and Configuration
Once you have inserted the card in the slot, turn the unit on. The unit
will try to recognize and configure the card.
If the unit responds with one beep when you turn it on, the
PhoenixCARD Manager Plus drivers successfully recognized and
configured the card. If the unit does not beep, the PC card drivers might
not be loaded in the unit, or the beeper might be disabled.
Note: In some cases, drivers provided by a specific card’s vendor are
responsible for configuring the card. If you are using one of
these cards, you might receive no audio signals for card
configuration. See the configuration instructions that came
with the card.
