The Four Slot Dock 7-9
2325A137REFGD Revision B 2325 Reference Guide
Installation
Power Adapter
Use one of the following:
• US: US style 110VAC plug
• International: 100–250VAC 47–63Hz input with IEC320
(includes power cord)
Cables
To connect the 4-Slot Dock to a host computer, use one of the following:
• RS-232 cable
• RS-422/485 cable (custom-built for your application)
To form a network of multiple 4-Slot Docks, connect the docks to each
other with either of the following LXE cables:
• Two-foot cable
• Ten-foot cable
Note: See Appendix A for pin assignments. See Chapter 1 section
titled “Accessories.”
Connecting the Dock
to the Host
To connect the 4-Slot Dock to a computer, complete the following steps:
1. Plug one end of the serial cable into the appropriate connector on
the back of the 4-Slot Dock.
2. Attach the other end of the cable to an available serial port on your
computer.
3. Attach the power adapter cord to the power input jack on the back
of the dock. (If you are using the international power adapter, plug
one end of the power cord into the power adapter.)
4. Plug the power cord into an outlet or power strip (preferably one
that has surge protection). The
POWER
LED on the front panel of
the dock should light up.
