Syntax and Parameters 5-3
2325A137REFGD Revision B 2325 Reference Guide
Option Description Default
Xmodem Zmodem
C# (Zmodem only) Specifies how the retransmission
of a file should be handled if a previous transfer
was interrupted. Replace the # symbol with the
desired setting:
1 = Never recover (start transmission from the
beginning of the file)
2 = Follow sender (use the sender’s crash-
recovery options; ignore the receiver’s)
3 = Always recover (send data from the point
where transmission was interrupted)
N/A 1
D# Specifies the number of seconds for XFER to
wait for activity before cancelling the transfer.
Replace the # symbol with the desired number of
seconds for the timeout delay. Acceptable values
are 0 (no timeout) through 65,535.
60 60
E# Specifies the maximum number of times XFER
should attempt retransmission of a packet after an
error occurs. If the final attempt fails, XFER
aborts the transfer. Replace the # symbol with the
desired maximum number of attempts. A setting
of 0 allows for unlimited attempts.
0 30
F# Specifies the type of flow control to use for data
transfer. Replace the # symbol with the desired
setting:
0 = No flow control
1 = XON/ XOFF (Zmodem only)
2 = RTS/ CTS
0 2
H or ? Displays help for the XFER command. None None
Ifile Specifies the modem-initialization file. Replace
file with the name of the file to use.
modem.ini modem.ini
Mcommand Sends a command to the modem before beginning
the data transfer. Replace command with one of
the following:
A = Auto answer
ATstr = Send ATstr commands
D#x = Dial memory #x (0–9)
Dstr = Dial phone number str
None None
N Forces XFER to ignore all previously specified
option settings, including filenames and options
specified in the XFER_ARGS environment
variable. All XFER options are set to their default
state.
Off Off
