6-8 System Utilities
2325 Reference Guide Revision B 2325A137REFGD
state for the same number of minutes. The range of acceptable values for
# is 0 (off) to 255; this option is off by default.
Note: The audio warning uses extra current, causing the batteries to
drain faster. Therefore, you might want to set the interval for
as long as possible or not use it at all.
/h
Displays a help file for the utility.
/i
Displays timer settings for auto-off, backlight timeout, and low-battery
audio indication.
/r
Resets power management to the cold-boot defaults.
/t#
Sets the auto-off timeout. Replace the # with the number of seconds of
nonuse before the unit should move to its lowest power state. The range
of acceptable values for # is 16 to 1032, or 0 for off; the default is 300
seconds (5 minutes).
VDISK.SYS
This driver configures all of the unit’s available extended memory as a
read/write disk, called a RAM disk. This driver is located on drive B of
the 2325 and is loaded by the CONFIG.SYS file located on that drive.
You cannot configure the parameters for this driver.
XFER.EXE
The XFER utility gives you the ability to transfer files to and from a PC
through the 2325’s serial port. For complete information about XFER,
see Chapter 5 “Using XFER.”
