2325A137REFGD Revision B 2325 Reference Guide
Appendix B
Programming Parameters
Introduction
This appendix contains information about programmable settings for the
2325. You can use the Configuration Utility or the barcodes provided in
appendix C to program your 2325. Also included in this chapter are
listings of files installed on the unit when using LXE’s terminal
emulation programs.
Note: New parameters added in Revision B: Ames Enable (ID 51)
and Spotting Beam Enable (ID D7).
The “Parameters, Settings, and Defaults” table (see next page) provides
the following information:
• Code Parameter is the “human” name for the programming
option.
• I.D. # is the “decoder” name for the programming option. For
example, if you wanted to set a Code 39 minimum label length,
you would use I.D. #01. Programming I.D. numbers given in
this appendix can be used with all programming methods.
• Type tells what kind of setting to use for each code parameter.
On/Off is a toggle. 1 turns the parameter on, and 0 turns it
off.
Value requires a two-character entry (e.g., 02 for two
beeps after each good read).
• Acceptable Input gives the settings or range of settings that
you can use for each code parameter.
• Defaults tells how the parameter is set when you select
predefined default D0, D1, or D2.
Predefined Default 0 (D0) turns every on/off parameter
off and sets all minimum and maximum lengths to the
lowest values.
Predefined Default 1 (D1) turns every on/off parameter
on, sets all minimum lengths to the lowest values, and sets
