2325A137REFGD Revision B 2325 Reference Guide
Appendix C
Barcodes for Configuring 2325
Introduction
This appendix provides barcodes for common setup parameters for
programming the 2325. Factory default settings are listed in the section
titled “Default Settings” and are included
as part of the parameter
heading.
Note: New parameters added in Revison B: Ames Enable (ID 51) and
Spotting Beam Enable (ID D7).
To make settings that aren’t provided here, you can use your own
barcodes. Using the barcodes contained in this section, you can change
any scanning system parameter or reset all parameters to their default
values. This chapter contains Code 39 barcode symbols for system setup
parameters.
Refer to the 2325 Installation and Operator’s Guide (LXE DocID
2325A136OPGDUS) for the section titled “Scanner Warnings and
Labels” for important laser safety information
before
using the scanner.
When scanning the barcodes in this section, remember:
•
Do not look into the laser’s lens.
•
Do not stare directly into the laser beam.
•
Do not remove the laser caution labels from the 2325.
•
Do not connect the laser barcode module to any other device.
The laser barcode module is certified for use with the 2325
only.
How To
Select the symbol parameter you want to scan. Lay this reference guide
flat on a table or propped up.
Holding the scanner approximately 6 - 12 inches away from the symbol,
scan the selected symbol.
When the Scan LED illuminates, the parameter has been decoded.
Note: Whether there are beeps in conjunction with scan and decode
functions is dependent on the application currently running in
